Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch until the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Front Bezel
Identify the front bezel highlighted in blue.
Unlock the front bezel by using the key.
Press the release button and disengage the left end of the bezel.
Unhook the right end, and remove the front bezel.
Drive backplane cover
Identify the drive backplane cover highlighted in blue.
Slide the drive backplane cover to the rear of the system.
Lift the drive backplane cover from the system.
Air shroud
Identify the air shroud highlighted in blue.
Holding the edges of the air shroud, lift the air shroud out of the system.
Cooling fan cage assembly
Identify the cooling fan cage assembly highlighted in blue.
Rotate the blue release levers to unlock the cage assembly from the system.
Hold the release levers, and lift the cooling fan cage assembly away from the system.
Side wall brackets Left
Identify the side wall brackets highlighted in blue.
Press the tabs to release the side wall cable holder.
Move the cables out of the side wall cable holder and observe the cable routing.
Press the center tab to release the bracket from the chassis, and lift it away from the system.
Control panel - Left
Identify the control panel highlighted in blue.
Remove the screws which secure the left control panels cable cover to the system.
Remove the cable cover away the system.
Disconnect the control panel cable from the system board connector.
Remove the screws which secure the left control panel assembly to the system.
Hold the left control panel cable, and slide the left control panel out of the system.
Install
Control panel - Left
Identify the control panel location highlighted in blue.
Align the left control panel assembly with the slot and slide into place.
Install the screws that secure the control panel assembly to the system.
Connect the left control panel cable to the connector on the system board .
Route the control panel cable through the side wall of the system.
Align and slide the left control panel cable cover in the slot on the system.
Install the screws to secure the control panel cable cover to the system.
Side wall brackets Left
Identify the side wall brackets location highlighted in blue.
Align and slide until the side wall brackets is seated firmly.
Close the side wall cable holder until the holder clicks into place.
Cooling fan cage assembly
Identify the cooling fan cage assembly location highlighted in blue.
Align and place the cooling fan cage assembly into the system until seated firmly.
Rotate the blue release levers to lock the cooling fan cage assembly into the system.
Air shroud
Identify the air shroud location highlighted in blue.
Tilt at an angle and align the tabs with the slots on the system and place the air shroud until it is firmly seated.
Drive backplane cover
Identify the drive backplane cover location highlighted in blue.
Align and place the drive backplane cover on the system.
Slide the drive backplane cover to the front of the system until it fits into place.
Front Bezel
Identify the front bezel location highlighted in blue.
Align and insert the tabs on the bezel into the slots on the system.
Press the bezel until the release button clicks in place.
Lock the front bezel by using the key.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a flat head or Phillips screwdriver, rotate the lock clockwise to the lock position.